Stratasys J826 User Guide
Printer waste contains partially cured polymeric material, collected during
Replacing the
normal operation and maintenance of the printer. For safety and
Waste
environmental reasons, this material is kept in a special leak-proof, disposable
Container
container.
The container has a capacity of about eight kilograms of waste material—
usually enough for several months of printer use. The printer application
displays a warning message when there are 7.3 kilograms of material in the
container, and stops the printing when the net weight reaches 7.8 kilograms.
Above 7.3 kilograms, the software does not allow you to start a printing job or
activity until you replace the waste container.
You can monitor the weight of the waste container in the Printer Indicators
display in the printer interface. You can also visually inspect the level of waste
in the container. To access it, see page 4-107.
To monitor the waste weight (and other indicators) in the printer:
➢ In the main printer interface screen, click the display toggle to view the
Figure 4-163 Printer interface, showing waste weight (red background
indicates operator alert)
DOC-28000 Rev. D
printer indicators.
4 Operating and Maintaining the Printer
4-106