Processor; Removing A Processor; Figure 36: Removing A Processor; Figure 37: Push First The Right Processor Locking Up And Then Then Lift The Processor Load Plate - Kontron ZINC CUBE C232 User Manual

4.19. Processor

4.19.1. Removing a Processor

ESD protection must be worn during the procedure to avoid damaging the components.
To remove a processor:
1. Power off the server, and then detach the power cord from the power supply.
2. Remove the top cover.
3. Remove the system board tray.
4. Remove the heat sink.
5. Press downward and outward on the right processor locking lever, pulling it fully open.

Figure 36: Removing a Processor

6. Lift the processor load plate to the fully open position.

Figure 37: Push first the right Processor Locking up and then then lift the processor Load plate

www.kontron.com
ZINC CUBE C232 - Rev. 1.0
// 51