Connect A Terminal Or Emulator To The Ser Mgt Port - Oracle SPARC S7-2L Installation Manual

See "Connect a Terminal or Emulator to the SER MGT Port" on page
Related Information
"Rear Panel Components (Installation)" on page 20
■
"Powering On the Server for the First Time" on page 75
■

Connect a Terminal or Emulator to the SER MGT Port

Prior to powering on the server for the first time, make a serial connection to the SP. After
making this serial connection, you will be able to view the system messages when you connect
the power cords.
Confirm that you have completed the following tasks.
1.
a. Completed the preparation for installation.
See "Preparing for Installation" on page
Completed the installation of the server in a rack.
b.
See "Installing the Server" on page
c. Connected the necessary cables.
See "Connecting Cables" on page
Connect a terminal or a terminal emulator (PC or workstation) to the server SER
2.
MGT port.
Configure a terminal or terminal emulator with these settings:
3.
9600 baud
■
8 bits
■
No parity
■
1 Stop bit
■
No handshake
■
A null modem configuration is needed, meaning the transmit and receive signals are reversed
(crossed over) for DTE to DTE communications. You can use the supplied RJ-45 crossover
adapters with a standard RJ-45 cable to achieve the null modem configuration.
Connect a Terminal or Emulator to the SER MGT Port
29.
33.
59.
Powering On the Server for the First Time
77.
77