Table of Contents
Advertisement
Panasonic Electric Works Nordic AB
MEW01349
25.10
Action
"Menu"
Scroll to menu H2.
"↵ "
Scroll to menu B10.
"↵ "
"↵ "
Rev: -
Operating Instructions Fire alarm system EBL512 G3, V1.1.x
De-activate Alert Annunciation function
(H2/B10)
Normal function:
For alarm points / zones programmed for Alert Annunciation (via
WinG3) is normally the AA function enabled via a time channel, e.g.
enabled daytime (during working hours) and disabled night time.
As an alternative, the AA function can be continuously enabled.
Off
Via this menu (H2/B10) it is possible to de-activate (disable) the AA
function, i.e. the AA function will be disabled for the alarm points /
zones programmed for Alert Annunciation in spite of the time channel
is "on" or if they are programmed to be continuously enabled.
The AA function will stay de-activated (disabled) until re-activated
(re-enabled) again via this menu.
Text in display
H2 Disable or re-enable
B1 Disable zone
B2 Disable zone / address
B3 Disable output
B4 Re-enable zone
B5 Re-enable zone / address
B6 Re-enable output
B7 Disable / re-enable output type
B8 Disable / re-enable alarm devices
B9 Disable / re-enable routing equipment
B10 De-activate alert annunciation function
B10 De-activate alert annunciation function
Alert annunciation function:
B10 De-activate alert annunciation function
Normal
Off
103
Comments
According to chapter
"Access", see page 85.
Select "Normal" or "Off".
Scroll to another menu or
press "ESC".
Advertisement
Table of Contents
