Table of Contents
Advertisement
SRN
Problem
DFFFF Note: The description and action for this SRN are valid only if you have
run diagnostics to the SSA attachment. If this SRN has occurred because
you have run diagnostics to some other device, see the service
information for that device.
|
|
Description: A command or parameter that has been sent or received is
|
not valid. This problem is caused either by the SSA adapter, or by an
|
error in the microcode.
Action: Go to "Software and Microcode Errors" on page 441 before
exchanging the FRU.
SSA01 Description: Not enough using-system memory is available for this service
aid to continue.
Action: Do one of the actions described here:
v This problem might be caused by a failed application program. Ask the
user to end any failed application program, then try to run the service
aid again.
v Run diagnostics in Problem Determination mode to the system unit. If
you find any problems, solve them, then try to run the service aid
again.
v Close down and reboot the using system, then try to run the service
aid again.
v Run diagnostics from diskette or CD-ROM to isolate the problem. If you
do not find a problem, the operating system might have failed.
SSA02 Description: An unknown error has occurred.
Action: Do one of the actions described here:
v Run diagnostics in Problem Determination mode to the system unit. If
you find any problems, solve them, then try to run the service aid
again.
v If diagnostics fail, or if the same problem occurs when you try the
service aid again, run diagnostics from diskette or CD-ROM to isolate
the problem. If you do not find a problem, the operating system might
have failed.
Chapter 18. SSA Problem Determination Procedures
Possible Causes
Software error.
Possible FRUs:
SSA adapter card (100%)
("Removing and Replacing
an Advanced SerialRAID
Adapter" on page 327).
None.
None.
439
Advertisement
Table of Contents
