Table of Contents
Advertisement
9. (from step 4)
Attention:
recovered. Before any other action is taken, the user must recover all the data that
is not damaged, and create a backup of that data.
a. Type
b. Select List Status Of All Defined SSA RAID Arrays.
c. Select, in turn, each array type that is used in your subsystem, and press Enter.
Are any arrays listed as having an invalid data strip as shown in the following
screen?
Note: This example screen shows the status of RAID-5 arrays. The screen shows
NO
YES
458
User's Guide and Maintenance Information
Part of the data that is on the array has been damaged and cannot be
and press Enter.
similar information if you select a RAID-1 array or a RAID-0 array.
Review the symptoms, then go to "MAP 2320: SSA Link" on page 445, and
start the problem determination procedure again.
a. Note the hdisk number of the failing array.
b. Go to step 10 on page 459.
Advertisement
Table of Contents
