Table of Contents
Advertisement
RAID-10 Array Split
Figure 39 shows a RAID-10 array that has been split into halves.
System 1
SSA Adapter
Figure 39. Forcing Access on a RAID-10 Array
The Split Array Resolution flag has been set to Secondary to permit I/O operations to
be performed on the secondary half of the array. Only user actions can set this
condition. Separate write operations can be performed to each half of the array. If these
write operations are performed, however, the two halves of the array must not be
reconnected.
206
User's Guide and Maintenance Information
Split Array Resolution
Split Array Resolution
= Primary
Primary 1
Primary 2
= Primary
Secondary 1
Secondary 2
System 2
SSA Adapter
Advertisement
Table of Contents
