Table of Contents
Advertisement
Diagnostic Information for Multiple Bus Systems manual). The microcode level is shown
in the ROS level field. Alternatively, give the following command:
where
You can determine the disk drive microcode level by using the Display/Download Disk
Drive Microcode SSA service aid (see "Display/Download Disk Drive Microcode Service
Aid" on page 393).
Maintaining the Adapter Microcode
Updates to microcode can be delivered on several types of media, or you can get them
|
from web page http://www.storage.ibm.com/hardsoft/products/ssa
1. Install the microcode as described in the instructions that are provided with the
2. Run the cfgmgr command (if you have not already done so) to download the new
3. If the SSA loops that are connected to this adapter contain two or more SSA
If the level of the microcode that is stored in the using system is higher than the level of
the microcode that is installed on the SSA adapter, the higher-level microcode is
automatically downloaded to the adapter when the using system runs its configuration
method.
Maintaining the Disk Drive Microcode
To download disk drive microcode, use the Display/Download Disk Drive Microcode
SSA service aid (see "Display/Download Disk Drive Microcode Service Aid" on
page 393).
adapter
is the ID of the adapter that you want to check.
installation media.
microcode into the SSA adapter.
adapters, and those adapters are installed in two or more using systems, load the
adapter microcode, then run the cfgmgr command on each using system.
Chapter 14. SSA Adapter Information
315
Advertisement
Table of Contents
