Table of Contents
Advertisement
3. The following information is displayed:
Select Disk to Remove, and press the List key.
4. From the displayed list, select the disk drive that you want to remove, and press
Enter.
Note: If the disk drive that you are replacing has been removed, or the array has
rejected it, it is listed as BlankReservedZ.
5. Select Disk to Add, and press the List key.
6. From the displayed list, select the name of the disk drive that you want to add, and
press Enter.
7. Press Enter to perform the swap operation.
Chapter 6. Using the RAID Array Configurator
143
Advertisement
Table of Contents
