Table of Contents
Advertisement
Chapter 4. Using the SSA SMIT Menus
This chapter describes how to use the system management interface tool (SMIT) to
display and change characteristics of the SSA devices, and to access various service
functions. Three SSA menus are available through the SMIT Devices menu.
v SSA Adapter
v SSA Disks
v SSA RAID Arrays
|
Notes:
|
1. Although this book always refers to the smitty commands, you can use either the
|
|
|
|
|
|
|
2. Different microcode levels might cause slightly different versions of the menus to be
|
|
3. If you use fast-path commands, you might need to go through intermediate steps
|
|
smitty command, or the smit command. The procedures that you follow remain the
same, whichever of the two commands you use. If you send the smit command
from a graphics terminal, however, the menus are displayed slightly differently from
those shown in this book. If you are not familiar with the selection of items from the
graphics versions of the menus, use the smitty command. The menus will then
appear as shown in this book.
displayed.
that are not shown in this book. Also, some menus might be displayed slightly
differently from those shown in this book.
39
Advertisement
Table of Contents
