3 Installation
All local and national electrical safety codes (NESC®) must be followed when installing the MP1. If there
is any contradiction in this manual and those standards, then the installer must follow the local and
national codes. Use copper conductors only.
3.1 Mounting the MP1
Install the MP1 in the desired location using appropriate hardware to connect the two mounting tabs to
the wall.
4.7" (119mm)
Figure 1 - TELSEC
®
MP1 Dimensions
©
Rev 3.0 9/15/22
- 3 -
TELSEC
MP1 User Guide