Shell Commands; Set Ip Command - Quest Controls TELSEC MP1 User Manual

10 Shell Commands

The MP1 supports a management shell that is accessible through SSH or Telnet. From this shell, the user
can issue various commands to administer the communications of the system. Use your favorite SSH or
Telnet client to connect to the MP1. The default username/password is Shelllevel/shelllevel. The
username/password can be changed or additional username/password combinations can be created
through the Telnet/SSH User Configuration on the web server. See section 8.1.9 of this manual. A
command prompt will be shown after a successful login. Type the word "show" to see the available
commands:
Available commands:
set ip
set mtu
set httppswd
set snmpmgr
set upgradeurl
set upgradecheck
ping
show
exit
logout
All commands when entered will execute without further confirmation to the user. When using the
"set" commands the system will output a message of "parameters set...unit will restart after you exit".
You can do multiple "set" commands and then type "exit" or "logout" to exit and reboot the system.
The system will then restart and come up with the new settings.

10.1 Set IP Command

Typing "set ip" only will show the current settings for the network configuration. To change the
settings, use the following format:
Format: set ip <ipaddress> <subnetmask> <gateway> <DNS1 | none> <DNS2 | none> <http_port>
Where:
<ipaddress> = the IP address for the device in decimal dot format
<subnetmask> = The subnet mask entered in decimal dot format
<gateway> = the gateway IP address entered in decimal dot format.
<DNS1 | none> = DNS 1 server IP address in decimal dot format or the word none when DNS is not used
<DNS2 | none> = DNS 2 server IP address in decimal dot format or the word none when DNS is not used
<http_port> = The port number to use for HTTP access.
Example:
set ip 192.168.1.58 255.255.255.0 192.168.1.1 8.8.8.8 8.8.4.4 80
©
Rev 3.0 9/15/22 - 43 - TELSEC MP1 User Guide