Table of Contents
Advertisement
Where 192.168.1.58 is the IP address, 255.255.255.0 is the subnet, 192.168.1.1 is the gateway, 8.8.8.8 is
DNS 1 server, 8.8.4.4 is DNS 2 server and the HTTP port is 80.
When there is no DNS then use the following example:
>set ip 192.168.1.58 255.255.255.0 192.168.1.1 none 80
10.2 Set MTU Command
Type "set mtu" to see the current settings. The set mtu command will change the size of the Maximum
Transmission Unit value. The default value is 1500.
Format: set mtu <value>
Example: set mtu 1200
Sets the max mtu size to 1200.
10.3 Set httppswd Command
The set httppswd command will change the passwords for the built in web server. There are a total of
six usernames (User1 – User5 & Admin) that can be change. Note this changes the password only and
does not change the access levels assigned to each username. To change the access level go to the web
server go to Settings/HTTP User Administration. See section 8.3.
Format: set httppswd <username> <pswd> <pswd copy>
Where:
<username> = User1, User2, User3, User4, User5, Admin
<pswd> = the password value used when logging into the webserver using the username
<pswd copy> = reenter the password again for confirmation.
10.4 Set snmpmgr Command
This command will allow you to set the four SNMP trap receiver addresses. Typing "set snmpmger"
without any parameters will show the existing settings for the four trap server addresses.
Format: set snmpmgr <#> <ipaddress|none> <v1|v2|v3> <Trap|Inform> <community string/v3
username>
Where:
<#> = The trap server number to be changed 1-4
<ipaddress|none> = IP address of the trap server or the word none to remove and existing definition
<v1|v2|v3> = the trap format to be used
<Trap|Inform> = Whether to send traps or informs to the server.
<community string/v3 username> = the SNMP community string to be used or one of the defined SNMP
user names to be used if sending v3 traps/informs (see section 8.1.7).
©
Rev 3.0 9/15/22
- 44 -
TELSEC
MP1 User Guide
Advertisement
Table of Contents
