Output Status; Alarm Status - Quest Controls TELSEC MP1 User Manual

6.2 Output Status

The output status page shows the current status of the digital outputs. Each output will be shown with
the defined name, Action which is either automatic (AUTO) or BYPASSED if a user has bypassed the
output (Settings/Bypass). The state field shows whether the point is Active or Inactive based upon the
user defined program. The last function is the ability to Acknowledge the current active state which will
cause the output to go to an inactive state until the next condition causing an Active state occurs.
Figure 12 - Digital Output Status

6.3 Alarm Status

The Alarm Status page will provide the current status of all the defined alarm points. Each alarm point
will be listed with the defined name, the name of the point being referenced in the alarm, a timestamp
when the alarm point last transitioned to its current value and the current value of the point.
Figure 13 - Alarm Status Page
©
Rev 3.0 9/15/22 - 14 - TELSEC MP1 User Guide