Local Operation; Power Led; Alarm Led; Relay Outputs - Quest Controls TELSEC MP1 User Manual

Table of Contents

4 Local Operation

Once the TELSEC

MP1 is installed, powered, and connected with an Ethernet connection, the system

will start operation based on the program controlling the unit. Under normal operation the green

Power LED will flash at one second intervals to indicate the system is operating properly. Occasionally

there may be a pause in this operation if the system is saving data to flash memory. If the LED is off for

longer than one minute, then check the power connection and cycle power to the unit. If the LED is

constantly on longer than a minute, then cycle power to the system to see if it goes back to normal

operation of flashing the LED.

The red alarm LED will be illuminated when any of the alarm points are in alarm. This LED does not

provide notification of the state of the control relays since an alarm point may be in alarm, but not

associated with an output. If this LED is illuminated, then log into the web server on the MP1 and

review the active alarm log on the home page.

Relay outputs are programmable for normally energized or de-energized condition. The normally

open/normally closed terminations on the board refer to when the output is de-energized. There are

two outputs that may be associated with an alarm severity or a time schedule. Outputs that are

associated to an alarm severity will be "active" when the alarms are present and will deactivate when

either all alarms with the associated severity have cleared or if the acknowledge function is

used. Outputs associated with a time schedule will be "active" when the schedule is on and de-

activated when the schedule is off. Outputs can be bypassed indefinitely or for a period of time

remotely via the built-in web server or by SNMP SET commands.

The TELSEC

MP1 has a small access hole next to the green power LED. Holding this switch in for

approximately 15 seconds during a power up (cycle power off then back on) will cause the system to

erase all programmed settings and go back to the factory defaults. During the Cold Start process, you

will see both the power LED and Alarm LED flash simultaneously every second. After a few seconds, the

alarm (red)LED will be illuminated solidly. Release the cold start switch once the alarm LED is on solid.

Rev 3.0 9/15/22

- 10 -

TELSEC

MP1 User Guide

Table of Contents