Quest Controls TELSEC MP1 User Manual page 30

8.1.8 RADIUS Configuration
If RADIUS is enabled, the MP1 will contact the defined server when a user attempts to log into the
system to determine if the username/password is valid. The MP1 will grant access if the
username/password is valid and will show the menu options based upon the user's access level defined
in the RADIUS server. See Appendix B - RADIUS Server Configuration for the required setting when
configuring the RADIUS server.
8.1.9 Telnet/SSH User Configuration
The MP1 supports SSH and Telnet for access to the system to receive alarms via TL1 (Appendix D – TL1
Alarms and Commands) or to access the Shell console for managing the network settings of the MP1
(section 10). The Telnet/SSH User Configuration section is used to set usernames, passwords, inactivity
timeout delay and the access type for up to nine different users. The default username/password for
the "shell" level is Shelllevel/shelllevel and for TL1 access it is TL1level/tl1level. Change the default
settings and or add additional users by entering the appropriate information and then select the access
type. Press the save changes button to write the settings to flash. Usernames are 8-32 characters in
length and can contain A-Z,a-z, 0-9 and special character _. Passwords are 8-32 characters in length and
can contain A-Z,a-z, 0-9 and special characters _@#%*-
Rev 3.0 9/15/22
Figure 30 - RADUIS server interface setup
- 25 -
©
TELSEC MP1 User Guide