Quest Controls TELSEC MP1 User Manual page 28

8.1.5 Time Settings
Use this section to either set the system clock manually or to turn on automatic time updates using an
NTP Server. This page will also allow you to enter a time zone for the system and configure daylight
savings time. In manual mode, the web page will allow you to set the time of the system manually by
clicking on the time field. This will bring up a dialog box for setting the time which will include a button
to set the time using time on your computer.
8.1.6 SNMP/SMTP General Configuration
Use this section to set up the common settings when using SNMP or SMTP (Email). When using
SNMPv3, you can have SNMPv1 & v2c active by putting in a Read and Write community string. Leave
these fields blank to disable v1 & v2c SET and GET operations. Contact Quest to obtain the MIB files for
the MP1. There is a specific MP1 MIB for doing SET and GET commands along with Quest's standard
Alarm MIB file for trap reception.
The SMTP setup is to allow the MP1 to send text-based emails when an alarm occurs. Enter the SMTP
server information, username and password if necessary, to allow the MP1 to connect to the sever for
sending email notifications. The email dispatch addresses and alarm severity are configured in the
Settings Alarm Dispatch page (section 8.2.2). The format of the email can be found in Appendix C –
Email Alarm Format
Rev 3.0 9/15/22
Figure 27 - System Clock Settings
- 23 -
©
TELSEC MP1 User Guide