Quest Controls TELSEC MP1 User Manual page 26

8.1.2 IPV4 Configuration
The MP1 supports dual stack for IPv4 and IPv6 or you can disable either IPv4 or IPv6. The default setting
is for IPv4 to be enabled and IPv6 disabled. The system will not allow a user to disable both. Use this
section to enable/disable IPV4 protocol and to configure an IP address for the unit. The system supports
DHCP or Static. If Static is chosen, then enter the desired IP address, Subnet mask and Gateway address.
8.1.3 IPV6 Configuration
The MP1 supports either dual stack for IPv4 and IPv6 or you can enable IPv6 and disable IPv4. Use this
section to enable IPv6 an configure the network address using either Auto configuration or manual
configuration. If Auto is chosen, then the system will display the address in the IP address field after
pressing the Save Settings button and the system goes through its restart. For manual configuration,
enter the IP address with the prefix and the gateway address without a prefix.
Rev 3.0 9/15/22
Figure 23 - Site Name and Information
Figure 24 - IP Address and Settings
- 21 -
©
TELSEC MP1 User Guide