Quest Controls TELSEC MP1 User Manual page 52

11.1.5 [snmp]
The SNMP general settings that are configured through Settings/General/ "SNMP/SMTP General"
Settings. This section also contains the heartbeat trap configuration which can be set through the web
server Settings/Alarm Dispatch/Heartbeat Configuration section.
11.1.6 [smtp]
The general email settings that are configured through Settings/General/ "SNMP/SMTP General".
11.1.7 [email]
This section will contain the email dispatch configuration that is created through the Settings/Alarm
Dispatch/Email Dispatch tab. The severity mask is as follows:
62 = All severities
56 = Critical, Major & Minor
48 = Critical and Major
32 = Critical only
0 = Disabled
11.1.8 [log]
This section is for internal use and should not be changed unless directed to do so by Quest Controls,
Inc. personnel. Changes to this section can impact the performance of your system and or render it
inoperable.
11.1.9 [snmpv3]
This section contains the SNMPv3 settings that are entered through the web server
Settings/General/SNMPv3 User Configuration tab.
11.1.10 [radius]
Settings for the RADIUS server connectivity that are entered through the web servers
Settings/General/Radius Configuration tab.
11.1.11 [telnetssh]
Settings used for Telnet and SSH access that are entered through the web servers
Settings/General/Telnet/SSH User Configuration.
11.1.12 [inputs]
This section is for defining inputs that are tied to the MP1 main board or Quest expansion boards. See
Section 9.1 for additional information on defining inputs.
Options:
#pt = The point number where the point is connected to the system. from 1-7
Name = The 32-character display name defined for the point
Type = tempf, tempc, dryno, drync, wetno, wetnc, custom
Offset = offset value to correct the sensor reading.
custom low = When input is defined as custom this value is the low end of the scale.
custom high = When input is defined as custom this value is the high end of the scale.
©
Rev 3.0 9/15/22 - 47 - TELSEC MP1 User Guide