Uploading Config Files - Quest Controls TELSEC MP1 User Manual

Example:
[schedules]
1,Gen_Start,130,420,2,450, 0,0,0,0,0,0,0,0,0,0,0,0,0,0,0,0,0,0,0,0,0,0,0,0,0,0,0,0,0
Priority 1 is ON Monday at 7 am and Priority 2 is OFF Monday at 7:30 am.
11.1.15 [alarms]
The alarms section will contain all defined alarm conditions for inputs, Modbus points and control point
types. See section 9.3 for additional information on defining date schedules.
Options
#Id = the four-character unique id assigned to the point.
display name= a 32-character display name for the device.
data id = the id number of the point used to create the alarm condition, i.e. UIN1, M001 (Modbus id#)
severity = critical, major, minor, notice, warning, none
comparison = greater_than, less_than, equal_to, not_equal_to
value = value to compare the data id point with to determine the alarm condition
qualifier = additional qualifier such as a time schedule or another alarm program. The field is blank if not
used.
alm delay = delay in seconds before the alarm is active when the comparison is true.
clr delay = clear delay in seconds to wait after the condition is no longer true before clearing.
nag = nag interval in minutes.
tl1 type = env, eqptsa, eqptnsa
Example:
[alarms]
#id,disp name, data id, severity, comparison, value, qualifier, alm delay, clr delay,nag, tl1 type
a001,Testing an alarm for input 15,uin15,major,greater_than,0.000000,,60,5,0,env

11.2 Uploading config files.

Once the upload file has been created go to the Settings/Advanced/Configuration Upload & Download
tab. Click on the Choose File option to select the file from your computer. The click on the Upload
Configuration from browser button. To load the file. The system will upload the file and then process all
of the sections. If there are no errors the system will indicate a successful upload and ask you to click on
the reboot button. Any errors found will be listed out in the upload status window. Correct the errors
and then resend the file. See section 8.4.2 for additional information.
©
Rev 3.0 9/15/22 - 49 - TELSEC MP1 User Guide