Table of Contents
Advertisement
9 Programming the System
Hovering on the Program menu will display the available program options. For all program pages the
system must save changes/additions to flash and do a reboot. When entering data, you will notice that
after pressing the Done button there will be a 60 second count down timer in the header. You will have
60 seconds to enter the next point information, which will reset the timer to 60 seconds again. You can
continue to add additional points in this manor or if you are completed, you can click on the Save and
Reboot button to save immediately instead of waiting for the time out.
9.1 Input Programming
The program input page will show all inputs that have been defined with their current settings. There
are a total of seven inputs. Inputs 1-6 correspond to the field terminals on the MP1 and input 7 is used
to monitor the incoming power to the MP1. The point names are hyperlinks to bring up a window for
changing the setting. The same window will appear when selecting the "Add new point" button.
Figure 41 - Defining Universal Inputs
Figure 42 - Add/Change Input Settings
©
Rev 3.0 9/15/22
- 32 -
TELSEC
MP1 User Guide
Advertisement
Table of Contents
