System Status; Input Status - Quest Controls TELSEC MP1 User Manual

5.2.1 The Home Page
After you log in with your username and password, the MP1 will display the Home page. This page can
also be displayed if you click on the home icon on the menu ribbon. The home page will show the Site
Information text box, status of the outputs and any Active Alarm condition. Outputs have an
acknowledge button to allow the user the ability to return the output to the inactive state. See

6 System Status

Hovering your mouse pointer on the Status option will provide the choices of Input Status, Output
Status and Log Data. This section of the manual will review each one of these options and the available
functions.

6.1 Input Status

The input status page will show the current value of the universal inputs currently programmed in the
system. The status page groups the inputs based on their definition into either digital inputs or analog
inputs. The display will show the digital inputs first followed by the analog points. Click on the expand
window icon to display the points.
6.1.1 Digital Inputs
Digital inputs will show the input number followed by the defined name of the point and the current
value. The page will show the ACCUMULATED ON which represents the entire time the input has been
active (ON), this timer can be cleared. The INTERVAL ON timer shows how long this input has been
active this time, when the input clears (OFF) this value will be held. When the input re-activates, this
timer will clear to zero and start counting. The INTERVAL OFF timer reacts similarly to the ON timer but
only counts when the input is off or inactive. The EVENT counter counts one for each change in state of
the input, on is one, off is two, next on is three and so on. The EVENT TIMER begins counting from the
time the input is programmed or from the time the input was last cleared.
Rev 3.0 9/15/22
®
Figure 9 - The TELSEC MP1 Home Page
- 12 -
Figure 9
©
TELSEC MP1 User Guide
.