Upgrade Url; Checking For Upgrades; Ping Command - Quest Controls TELSEC MP1 User Manual

Table of Contents

Advertisement

Example: set snmpmgr 1 192.168.1.104 v2 Inform Trap
Sets the first trap manager to IP address 192.168.1.104 and will send SNMP v2c informs with a
community string of Trap.

10.5 Upgrade URL

The set upgradeurl will allow the user to change the IP address and path of where the Ethernet module
can locate upgrades. Typing "set upgradeurl" and pressing enter will show the current location of where
upgrades can be found when the system is told (through the web server link or the upgrade command)
to check for upgrades. The format for changing the location is as follows:
Format: set upgradeurl <ipaddress/filelocation>
Example: set upgradeurl 192.168.1.105/MP1

10.6 Checking for Upgrades

The set upgradecheck command can be used to have the system go check to see if there is an available
upgrade and if so, the system will upgrade to the version stored on the upgraded server assuming the
build number of the code is greater than what is currently running in the MP1. Entering "set
upgradecheck" will show the current firmware build number. Entering "set upgradecheck on" will cause
the system to check for and perform the upgrade.
Example:
Command:
set upgradecheck
Response:
kernel version is #2 Fri Oct 4 10:28:18 PDT 2019
filesystem version is 2
Command:
set upgradecheck on
Response:
upgrade check turned on...unit will restart and check after you exit

10.7 Ping Command

The ping command will allow you to verify communications on the network. This command can be
helpful when reusing an IP address for the MP1. By doing the ping, the Ethernet switch the MP1 is
connected to will update its ARP table for the new MAC address of the unit.
Format: ping <ipaddress>
Example:
Command:
ping 192.168.1.1
Response:
PING 192.168.1.1 (192.168.1.1): 56 data bytes
64 bytes from 192.168.1.1: seq=0 ttl=64 time=10.726 ms
64 bytes from 192.168.1.1: seq=1 ttl=64 time=0.758 ms
64 bytes from 192.168.1.1: seq=2 ttl=64 time=0.775 ms
64 bytes from 192.168.1.1: seq=3 ttl=64 time=0.802 ms
Rev 3.0 9/15/22
- 45 -
©
TELSEC
MP1 User Guide

Advertisement

Table of Contents
loading

Related Products for Quest Controls TELSEC MP1

Table of Contents