Connecting A Qfx5100 Switch In A Virtual Chassis Fabric; Figure 47: Maximum Qfx5100-96S Ring Configuration - Juniper QFX5100 Hardware Manual
Hide thumbs
Also See for QFX5100:
- Hardware manual (300 pages) ,
- Hardware documentation (966 pages) ,
- Quick start manual (2 pages)
Table of Contents
Advertisement
Related
Documentation
Connecting a QFX5100 Switch in a Virtual Chassis Fabric
Copyright © 2014, Juniper Networks, Inc.
Figure 47: Maximum QFX5100-96S Ring Configuration
Port Panel of a QFX5100-96S Switch on page 22
A Juniper Networks Virtual Chassis Fabric (VCF) is constructed using a spine-and-leaf
architecture and topology. In the spine-and-leaf architecture, each spine device is
interconnected to each leaf device. A VCF supports up to twenty total devices, and up
to four devices can be configured into spine devices. Supported devices in a VCF are:
QFX5100-24Q (spine or leaf)
QFX5100-48S (spine or leaf)
QFX3600 (leaf)
QFX3500 (leaf)
EX4300 (leaf)
BEST PRACTICE:
leaf devices.
Chapter 17: Connecting the QFX5100 Device
Use QFX5100-24Q as spine devices and QFX5100-48S as
183
Advertisement
Table of Contents
