Advertisement
ASSEMBLY
Wing Rear Scraper
Installation
1. With the Wing Rollers on level ground, place the
5/8-11 U-bolts over the frame tube and through the
Wing Scraper Brackets, secure with Flanged
Locknut. See Figures 2-72 and 2-73.
NOTE
A scraper can be used as a guide to achieve the 1/4"
gap.
U-Bolt,
3/8-16
2-78
TABLE OF CONTENTS
Flanged Locknut,
5/8-11
U-Bolt,
5/8-11
U-Bolt,
Tube
5/8-11
Flanged Locknut,
5/8-11
Figure 2-68: Wing Rear Scraper Installation
2. Assemble the Scraper Tube to the Wing Scraper
Brackets with a 3/8-16 U-Bolts, Scrapers and Flanged
Locknuts. Center the Scraper between the Notched
Wheels and adjust the Scraper so that there is a 1/4
gap between the Scraper and Notched Wheel.
Tighten.
3. Attach the Scrapers to the Scraper Tube with 3/8-16
U-Bolts and Flanged Locknuts, ensure that the
scrapers are centered between the Notched Wheels
along with a 1/4" gap between the Scraper and
Notched Wheel.
Wing Scraper Bracket
Scraper
Flanged Locknut,
3/8-16
3630-30NC Wing RearScraper
Wing Scraper Bracket
Scraper
Flanged Locknut,
3/8-16
U-Bolt,
3/8-16
Tube
F-982-0223
Advertisement
