Advertisement
MAINTENANCE
LED Warning Lamps
When plugging in the LED 7-Pin Connector:
1. Make sure the tractor has a good clean receptacle,
free of dirt and corrosion.
2. Make sure the 7-Pin Connector is inserted ALL the
way in. With tighter fitting pins, operator may think the
connector is all the way in, but really isn't.
3. Make sure the tractor receptacle cover latches over
the keyway on the 7-Pin Connector to hold the
connector in place.
If an operator plugs in the 7-Pin Connector, but the lights
do not seem to work right, check the above items to make
sure there is a good connection with the 7-Pin Connector.
Amber
LED Lamp
Red LED Lamp
LED Warning
Lights Harness
7-Pin/4-Pin
WP Harness
Figure 4-7: LED Warning Lamps
4-8
TABLE OF CONTENTS
Amber
LED Lamp
Flasher Control
Module
Storage
1. The service life of the Pulvi-Mulcher will be extended
by proper off-season storage practices. Prior to
storing the unit, complete the following procedures:
a. Completely clean the unit.
b. Inspect the machine for worn or defective parts.
Replace as needed.
c. Repaint all areas where the original paint is worn
off.
d. Grease all exposed metal surfaces of shanks and
points.
e. Apply a light coating of oil or grease to exposed
cylinder rods to prevent them from rusting.
f. Lubricate each point of the machine as stated in
"Lubrication Points and Intervals" on
page 4-4.
2. Store the unit in a shed or under a tarpaulin to protect
it from the weather. The ground tools and tires should
rest on boards, or some other object, to keep them out
of the soil.
3. If the unit is stored in the folded position, make sure
the transport lock pins are installed to prevent settling.
4. Relieve Hydraulic Pressure in hoses after locks are
installed.
5. Block wheels before unhitching from tractor.
F-982-0223
Advertisement
