Advertisement
Bearing Hanger and Wing
Rest Installation
1. Assemble a Rubber Bumper onto each Wing Rest
Bracket with 1/2-13 x 3-1/2 Bolts, Flat Washers and
Locknuts. See Figure 2-43.
Bolt,1/2-13 x 3-1/2
Flat Washer,1/2
Locknut,5/8-11
Bolt,3/4-10 x 2-3/4
U-Bolt,5/8-11
Bolt,3/4-10 x 2-1/4
F-982-0223
TABLE OF CONTENTS
Figure 2-41: Wing Rest and Bearing Hanger
2. Attach Bearing Hanger to Wing Frame on the Bottom
with 3/4-10 x 2-1/4 Bolts and Locknuts. Do Not
Tighten at this Time. Place the Wing Rest Bracket
over the outside of the Bearing Hanger. Assemble the
Wing Rest Bracket and Bearing Hanger onto the Wing
Frame with 3/4-10 X 2-3/4 Bolts and Locknuts.
Tighten the 3/4-10 Bolts at this time.
3. Secure the end of the Wing Rest to the Wing Frame
with 5/8-11 U-Bolts and Flanged Locknuts.
Rubber Bumper
Wing Rest Bracket
Locknut,1/2-13
Locknut,3/4-10
3630-25 OpWingBrgHanger
ASSEMBLY
Front
2-49
Advertisement
