Advertisement
ASSEMBLY
Shank Depth Control
Installation
1. If not already done, install Limit Valve, Slide Pad and
Depth Stop Guide to Limit Valve Mount located at the
front of the left side frame cross tube with 5/16-18 x
5-1/2 Bolts and Locknuts. See Figure 2-35.
2. Attach the Depth Stop Clamp on the top of the Middle
Tooth Tube by sliding a Clamp Plate into the Depth
Stop Clamp Slot and under the Tooth Tube.
Assemble 5/8-11 x 5 Bolts and Locknuts, Do Not
tighten at this time.
Depth Stop Guide
Depth Stop Asm
2-40
TABLE OF CONTENTS
Locknut,5/16-18
3630-30NC SPDC
Figure 2-33: Shank Depth Control Installation
3. Slide the Depth Stop Assembly through the Depth
Stop Guide to the Depth Stop Clamp. Position the
Depth Stop Assembly over the Depth Stop Clamp Lug
and align the Top Hole of the Depth Stop Clamp for
the 24" Roller Wheels. Insert and secure with 5/8-11
x 2-3/4 Bolt and Flanged Locknut. See Figure 2-35.
4. Ensure that the Depth Stop Clamp is positioned
correctly and that the Depth Stop Assembly moves
freely when turning the handle.
5. Tighten the Depth Stop Clamp Bolts at this time.
Bolt,5/8-11 x 2-3/4
Limit Valve
Bolt,5/16-18 x 5-1/2
Locknut,Flanged
5/8-11
Depth
Stop Clamp
Clamp Plate
Bolt,
5/8-11 x 5
Locknut,5/8-11
Pad Slide
F-982-0223
Advertisement
