Advertisement
ASSEMBLY
Plumb Lift Circuit
1. Attach the Counter Balance Valve to the inside frame
bracket with 5/16-18 x Bolt, Flat Washer, Lock
Washer and Nut, See Figures 2-25 and 2-26.
2. Install Counter Balance Valve fittings. See
Figure 2-27.
Bolt,5/16-18 x 2
Flat Washer,5/16
Lock Washer,5/16
Nut,5/16-18
Counter Balance
Valve
Figure 2-24: Counter Balance Valve
3. Attach Hoses to Counter Balance Valve. Route the
Hoses to the right side of the Drawbar and clamp
each set of system's hoses with hose clamps. Secure
with Flat Washer under the head of 3/8-16 x 5 Bolt
and Locknut. Continue routing the hoses to the front
of the Drawbar up the Hose Holder Bracket. If not
already done, install 3/8-16 x 5 Bolt onto Hose Holder
Bracket with Hex Nut. Place the Hose Holder Clamp
over the bolt and hoses. Secure with Hose Holder
Wing Nut. See Figures 2-10 and 2-26.
4. Install the Lift Cylinders and Hitch Leveler 4 x 8
Cylinder fittings.
2-28
TABLE OF CONTENTS
A Restrictor is used in the base end of the Hitch
Leveling 4 x 16 Cylinder. Removal of this restrictor
can cause uncontrolled movement of the front of
the machine. Improper installation can result in
serious damage to the implement.
5. Install Restrictor and Branch Tee into the base end
6. Install Lift Cylinder and Hitch Leveler Hoses.
7. Secure all hoses with Cable Ties and Tie Wraps.
8. Install Wings if not already assembled. See "Wing to
9. Assemble Lifts on Wings. See Figures 2-23 and
10. Install 4 x 14 Cylinders on Wing Lifts.
11. Install Wing Rests and Bearing Hangers if not
12. Assembly Wing Lift Cylinder Hoses. See
Frame
Bracket
CAUTION
and O-Ring Branch Tee into the rod end of the 4 x 16
cylinder. See Figures 2-26 and 2-27.
Wrap the Lift Circuit System hoses near the Tractor
Tips with Blue Hose Wrap.
Frame Installation" on page 2-50.
2-24.
assembled. See "Bearing Hanger and Wing Rest
Installation" on page 2-49.
Figures 2-26 and 2-27.
F-982-0223
Advertisement
