Advertisement
ASSEMBLY
Rear 3-Bar Coil Tine Harrow
Without Lift Installation
CAUTION
Do not work on or under this machine unless
securely blocked and supported by a hoist or
tractor or by other sufficient means.
WARNING
Do not attempt to lift heavy parts manually. Use a
hoist or forklift to move heavy parts into position.
NOTE
Wing Harrow Arms are different than Center Frame
Harrow Arms.
Refer to Figures 2-81 and 2-82 for the Harrow Arm
positioning.
1. Unfold, lower the unit to the ground.
2. Position Harrow Arm Assembly on the Center Frame
Rear Roller Tube or Wing Frame Rear Tube. Secure
with 3/4-10 U-Bolts and Locknuts. See Figure 2-79.
3. Attach the Harrow Assemblies to the Harrow Arm
Assemblies by placing the 3 x 3 tube into the Arm
Notch. Position 5/8-11 U-Bolt onto the 3 x 3 Tube and
through the Harrow Arm Assembly. Secure with Thick
Washers and Flange Nuts. See Figure 2-80.
Harrow Arm
Assembly
Center and Wing Frame
Rear Frame Tube
U-Bolt,3/4-10
Figure 2-75: Harrow Arm Installation to Frame
2-86
TABLE OF CONTENTS
Harrow Arm
Assembly
Harrow
Assembly
Figure 2-76: Harrow Arm Installation to Harrow
Locknut,
3/4-10
Thick Washer
Locknut,Flange
U-Bolt,5/8-11
Assembly
5/8-11
Harrow
Assembly
3 x 3 Tube
F-982-0223
Advertisement
