Advertisement
ASSEMBLY
Center Frame 2-Row Harrow
Installation
1. Remove 1 x 7-5/16 Pin from each Frame Adjuster
Mount located on the inside of the Outer Frame Tube.
Insert a Harrow Adjustment Tube into each Frame
Adjuster Mount and re-insert 1 x 7-5/16 Pin in the
bottom hole. Secure with 3/16 Hair Pin Cotters. See
Figure 2-37.
2. The 2-Bar Harrow comes factory assembled. Lift
Harrow Assembly and slide the Harrow 3 x 3 Tube
into the cut-out portion of the Harrow Adjustment
Tube and insert a 1/2-13 U-Bolt on each side. See
Figures 2-37 and 2-38. Check Harrow position in
relation to the Frame and secure with Flat Washer
and Locknut.
3. Install a 1/2-13 x 5 Bolt and Locknut into the top hole
of each Harrow Adjustment Tube.
4. Remove from one end of the Frame Adjuster Mount,
the Harrow Height Adjuster Handle Tube. Slide the
Harrow Adjuster Tube onto the installed Harrow
Height Adjuster Handle Tube. Re-install the removed
Harrow Height Adjuster Handle Tube and Roll Pin.
Secure Harrow Adjuster Tube with 3/8-16 x 2-3/4
Bolts, Flat Washers and Locknuts.
2-42
TABLE OF CONTENTS
F-982-0223
Advertisement
