MAINTENANCE
Clamp End Spacers -
Optional
The Clamp End Spacer Kits are used to eliminate space
between the Axle Clamp and the Wheel Stop.
IMPORTANT
Unfold and lower machine prior to performing any
steps.
Kit Part Number 201442 - 3/4" Axle Spacer
Kit Part Number 201443 - 1/2" Axle Spacer
Bolt,
3/8-16 x 1-3/4
Locknut,3/8-16
4-6
TABLE OF CONTENTS
Bolt,3/8-16 x 1-3/4
Wheel Stop
Axle Spacer
Axle Spacer
Figure 4-5: Clamp End Spacer Kit - Optional (1 of 2)
Installation is the same for either kit.
1. Place the two Axle Spacers between the Axle Clamp
and the Wheel Stop.
2. Insert two 3/8-16 x 1-3/4 Bolts through the Axle
Spacers and secure with 3/8-16 Locknuts.
3. Refer to the Torque Table for proper bolt torque
values.
NOTE
The different torque requirement for Bolts with Locknut.
See Page 4-1.
Axle Spacer
Axle Clamp
Locknut,3/8-16
Axle Spacer
201442-201443 ClampEndSpacerKit
F-982-0223