Advertisement
ASSEMBLY
Shank Installation
Engage Transport Locks
It is easier to bolt the points to the shanks before
mounting them on the machine.
NOTE
If machine requires Optional Front Scrapers. Lower the
machine on a level surface and install scrapers before
installing shanks. See scraper section on page 2-76.
Front installation is similar to rear. It is easier to install
shanks while machine is raised.
Lock Washer,7/16
2-38
TABLE OF CONTENTS
Locknut,1/2-13
Nut,7/16-14
Lock Washer,7/16
Figure 2-32: Shank Installation
Assemble Points to Shanks as shown in Figure 2-34.
Mount the Shanks to the Tooth Control Tubes using two
1/2-13 x 5 Bolts and Locknut. See Figure 2-31 for Center
Shank Mounting Dimensions.
Bolt,1/2-13 x 5
3630 OpShankPoints
2" Reversible
Point
Plow Bolt,
7/16-14 x 1-3/4
Flat Washer,7/16
F-982-0223
Advertisement
