Advertisement
ASSEMBLY
LED Warning Lamp
Installation
NOTE
Be sure when assembling Lamps onto Bracket that the
wires are not pinched when tightening hardware.
1. Attach the Light Brackets onto the Rear Roller Frame
Tube with 5/8-11 U-Bolts and Flanged Locknuts. See
Figures 2-41 and 2-42.
2. Assemble the Amber LED Lamps and Reflector
Assemblies with the cutout and the yellow reflective
decal facing the front of the machine onto the outer
Light Brackets by placing a Flat Washer under the
head of the 1/4-20 x 1-3/4 Bolts and inserting the bolt
through the lamp. Secure with Locknuts. Assemble
the Red LED Lamps with the lens facing the rear of
the machine and Reflector Assemblies onto the inner
Light Brackets in the same manner.
3. Attach the Flasher Control Module to the Module
Bracket on the RH Frame Inner rear tube using two
1/4-20 x 1-1/2 Bolts and Locknuts. See Figure 2-39.
Bolt,
1/4-20 x 1-1/2
AG Harness,40ft
Figure 2-37: Flasher Control Module
IMPORTANT
Cords are marked Yellow Tape for Left and Green
Tape for Right.
4. Lay out the Lamp Harness, noting that the connectors
marked with Green Tape is Right Side and Yellow
Tape is Left Side. Plug the Lamp Harness into the
Flasher Control Module.
5. Route Green Tape cords along the right side of the
Rear Roller Frame. Plug the 3-Prong Cord into the
Red Lamp. Plug the 2-Prong Cord into the Amber
Lamp.
2-46
TABLE OF CONTENTS
LED Light Harness
Cable Tie
Locknut,
1/4-20
Flasher Control
Module
6. Repeat for the Left Side (Yellow Tape).
7. Plug the 7-Pin Harness 4-Pin Weather pack plug into
the Flasher Control Module, then route the harness
along the inner RH Frame Tube, down the Drawbar
and through the Hose Holder following the hydraulic
hoses.
8. Bundle and secure excess cord to the Light Bracket
with tie wraps. Secure cords along frame using tie
wraps.
NOTE
All wires must be firmly attached to machine frame
members so they do not sag or become torn loose by field
debris.
SMV Sign Installation
Attach the SMV Mount to the center frame using 5/8-11
U-bolt and Flanged Locknuts. Attach SMV sign to mount
using two 5/16-18 x 1 Bolts, Flat Washers and Locknuts.
See Figure 2-40.
Mount,SMV
Locknut,
5/16-18
U-Bolt,5/8-11
Figure 2-38: SMV Sign Installation
SMV
Bolt,
5/16-18 x 1
Flat
Washer,5/16
Flanged
Locknut,5/8-11
F-982-0223
Advertisement
