Advertisement
ASSEMBLY
Center V-Leveler Installation
- Optional
Kit Part Number 214024
V-Leveler Wing and Land Leveler Wing Installation is
similar. Refer to Wing Placement Dimensions, See
Figure 2-85.
1. Place the cutout of the V-Leveler Bracket on top and
center it on the Drawbar Rear Cross Tube. Secure
with 5/8-11 U-Bolts and Locknuts. See Figure 2-86.
2. Position the Leveler Links on each side of the
V-Leveler Bracket and insert 1 x 7 Pin. Place a Flat
Washer on each side of the Pin and secure with 5/16
x 2 Roll Pin and Klik Pin.
3. Lift the V-Leveler up and align the single bottom hole
of the Link with the V-Leveler and insert 1 x 8 Pin.
Place a Flat Washer on each side of the Pin and
secure with 5/16 x 2 Roll Pins.
4. Mount the two longer Leveler Mounts to the Center
Frame Front Roller Frame Tube directly above the
V-Leveler Mounting Straps with 3/4-10 x 6-13/16 x
7-3/4 U-Bolts, Flat Washers and Locknuts. Do Not
tighten at this time.
5. Lift the V-Leveler Strap into the longer Leveler Mount
opening and insert 1 x 3 Clevis Pin. Place a Flat
Washer on the Pin and secure with Hair Pin Cotter.
6. Adjust the Longer Leveler Mounts on the Front Roller
Frame Tube accordingly and tighten the 3/4-10
U-Bolts. Install a 3/8 x 2-1/2 Cotter Pin at the top of
each V-Leveler Strap.
Wing V-Leveler Installation
1. Attach the Leveler Mounts to the Front Wing Frame
Tube with 3/4-10 x 5-25/32 x 7-1/4 U-Bolts, Flat
Washers and Locknuts. See Figure 2-86.
2. Slide the Wing Leveler Bar up into the mount slot and
insert 1/2-13 x 3 Bolt.
3. On the opposite side place the 1 x 1-1/2 Bushing over
the bolt and into the opening secure with Flat Washer
and Locknut. Insert 3/8 x 2-1/2 Cotter Pin into the
upper hole and spread.
2-92
TABLE OF CONTENTS
F-982-0223
Advertisement
