Advertisement
ASSEMBLY
Drawbar Leveling Installation
1. Assemble the Leveling Cylinder Bracket to the center
of the Front Roller Frame Tube with 3/4-10 U-Bolts
and Locknuts. Do Not Tighten at this time. See
Figure 2-13.
2. Install Tie Rod Assembly to the Front Cross Tube Lug
bottom hole and insert 1 x 3-1/4 Clevis Pin. Add a 1 x
2 x 11ga Washer and secure with 3/16 x 1-1/2 Cotter
Pin.
3. Put the base end of the 4 x 8 Hydraulic Cylinder
between the Leveling Cylinder Bracket Lugs. Swing
the Tie Rod Assembly between the Cylinder Base
End Clevis and insert 1 x 6 Pin. Place a 1 x 2 x 11ga
Washer on each side and secure with 5/16 x 2 Roll
Pins. Pivot the Hitch Leveler Link and attach it to the
rod end of the 4 x 8 Cylinder with the vendor supplied
hardware. Tighten Leveling Cylinder Bracket
Hardware.
Washer,
1 x 1-1/2 x 14ga
2-14
TABLE OF CONTENTS
Washer,1 x 2 x 11ga
Leveling Cylinder
Hydraulic
Bracket
Cylinder,4 x 16
Leveler
Mount
Hitch
Cylinder Link
Hitch
Leveler
Remove and Discard 5/8-11 x 10 Bolt,
Flat Washers and Hex Nut
Figure 2-12: Drawbar Leveler
IMPORTANT
Remove and discard the 5/8-11 x 10 Bolt, Flat Washer
and Hex Nut that is holding the Hitch Leveler together,
so that the outer portion can pivot rearward.
4. Attach the base end of 4 x 16 Hydraulic Cylinder onto
the Front Cross Tube Lug top hole with the vendor
supplied hardware. Pivot the rod end of the Cylinder
between the Leveler Mount and insert 1 x 10-1/8 Pin
though components. Place a 1 x 1-1/2 x 14ga Washer
on each end of the Pin and secure with 5/16 x 2 Roll
Pins.
5. Place the Transport Lock for 4 x 16 Cylinder over the
Storage Tube on the LH Frame Hitch Pull Bracket and
secure with Bent Pin and Hair Pin Cotter.
6. Adjust Turnbuckle if necessary.
Tie Rod
Assembly
Bent Pin
Hydraulic
Cylinder,4 x 8
Hair Pin
Roll Pin,
5/16 x 2
Pin,
1 x 10-1/8
Clevis Pin,
Cotter Pin,
1 x 3-1/4
3/16 x 1-1/2
Washer,
1 x 2 x 11ga
Roll Pin,
5/16 x 2
Pin,1 x 6
Locknut,
3/4-10
U-bolt,3/4-10
Transport Lock
Storage Tube
Transport Lock
F-982-0223
Advertisement
