Advertisement
ASSEMBLY
Rockshaft Installation
WARNING
Do not attempt to lift heavy parts (such as the
frame, rock shaft, and pull hitch) manually. Use a
hoist or a fork lift to move these parts into
position.
Bolt,3/4-10 x 2
UHMV
Bearing
Lift Cap Bearing
2-6
TABLE OF CONTENTS
Locknut,3/4-10
Figure 2-5: Rockshaft Installation
1. Spread open the six UHMV Bearings and place them
onto the Rockshaft. Make sure the mounting surface
is free of rust or dirt. See Figure 2-6.
2. Position the Rockshaft into the Frame Mounts. Place
the Lift Cap Bearing and fasten with 3/4-10 x 2 Bolts
and Locknuts. Ensure the UHMW Bearings are
seated properly into Caps and Frame Mounts. Repeat
for the remaining Lift Cap bearings. Tighten bolts. See
Page 4-1.
UHMV Bearings
Front
Rockshaft
F-982-0223
Advertisement
