loose until completion of final assembly. Use washers as CAUTION specified. After completion of final assembly, tighten all nuts Do not work on or under this machine unless evenly to prevent misalignment, distortion or binding. securely blocked and supported by a hoist or Tighten all screws and nuts to the recommended torques.
Page 4
Harrow Arm Installation 2. Position the Arm Assembly onto the rear of the tube. Place four hole plate on opposite side and slide four 1. Refer to Figures 1-4, 1-6 and 1-7 for Harrow Arm bolts through plate holes into Arm Assembly. Secure positioning.
Page 5
3. Attach the Harrow Assembly to the Harrow Arm Position U-bolt onto 3 x 3 tube and through the Harrow Assembly by placing the 3 x 3 tube into the Arm Arm Assembly. Notch. Secure with Thick Washer and Flange Nut. See Figure 1-3.
Page 10
Table provided for general use. NOTES: F-984-0418...
Page 11
Document Control Revision Log: Date Revision Improvement(s) Description and Comments 04/2018 Initial Release...
Page 12
Equipment from Landoll Corporation is built to exacting standards ensured by ISO 9001 registration at all Landoll manufacturing facilities. 3630-25 Coil Tine Harrow Kit 213907 3630-30NC Coil Tine Harrow Kit 213908 Instruction Sheet Re-Order Part Number F-984-0418 LANDOLL CORPORATION 1900 North Street...