Advertisement
ASSEMBLY
Wing 2-Row Harrow
Installation
1. Remove 1 x 7-5/16 Pins from each Wing Frame
Adjuster Mount. Insert a Harrow Adjustment Tube into
each Wing Frame Adjuster Mount and re-insert 1 x
7-5/16 Pin in the bottom hole. Secure with 3/16 Hair
Pin Cotters. See Figures 2-65 and 2-66.
Pin,1 x 7-5/16
U-Bolt,5/8-11
2-70
TABLE OF CONTENTS
2. The LH and RH Wing 2-Bar Harrow comes factory
3. Install a 1/2-13 x 5 Bolt and Locknut into the top hole
Locknut,1/2-13
Harrow Assembly
Figure 2-61: Left Hand Wing Harrow
assembled. Lift Harrow Assembly and slide the
Harrow 3 x 3 Tube into the cut-out portion of the
Harrow Adjustment Tube and insert a 1/2-13 U-Bolt
on each side. Check Harrow position in relation to the
Frame and secure with Flat Washer and Locknut. See
Figures 2-67 and 2-68.
of each Harrow Adjustment Tube.
Front
Bolt,1/2-13 x 5
Harrow
Adjustment Tube
Flat Washer,5/8
Locknut,5/8-11
F-982-0223
Advertisement
