ASSEMBLY
Wing Tooth Control Cylinder
Installation
Install the base end 4 x 8 Rephasing Hydraulic Cylinders
to the Cylinder Anchors on the front of the LH and RH
Wing Frames with the vendor supplied hardware. Adjust
the Anchor Nuts to achieve a distance of approximately
6-1/2" from the Center Frame Tube to the center of the
Cylinder Pin. See Figure 2-53.
2-58
TABLE OF CONTENTS
Cylinder Anchor
Nuts
6 1/2"
REF
Hyd Cylinder
4 x 8
RH Wing Frame
Figure 2-50: Wing Tooth Control Cylinder Installation
LH Wing Frame
3630-30NC OpWingToothCtrlCyl
Cylinder Anchor
6 1/2"
REF
Hyd Cylinder
4 x 8
Nuts
F-982-0223