Advertisement
Wing Shank Installation
1. Engage Transport Locks
NOTE
It is easier to bolt the points to the shank before mounting
them on the machine.
NOTE
If machine requires Optional Front Scrapers: Lower the
machine on a level surface and install scrapers before
installing shanks. See scraper section on page 2-78.
Front Scraper installation is similar to rear. It is easier to
install shanks while machine is raised.
Lock Washer,7/16
F-982-0223
TABLE OF CONTENTS
Locknut,1/2-13
Nut,7/16-14
Lock Washer,7/16
Figure 2-60: Wing Shank Installation
2. Assemble Points to Shanks as shown in Figure 2-64.
3. Mount the Shanks to the Wing Tooth Control Tubes
using two 1/2-13 x 5 Bolts and Locknut. See
Figures 2-57 and 2-58 for Left and Right hand Shank
Mounting Dimensions.
Bolt,1/2-13 x 5
3630 OpShankPoints
2" Reversible
Point
Plow Bolt,
7/16-14 x 1-3/4
Flat Washer,7/16
ASSEMBLY
2-69
Advertisement
