Advertisement
ASSEMBLY
Drawbar Installation (Manual
Jack)
1. Attach the bottom of the Hitch Leveler to the Drawbar
by removing the 5/16 x 2 Roll Pin, 1-1/4 x 2-1/2 12ga
Washer and 1-1/4 x 12-1/2 Pin. Position the Hitch
Leveler between the center lugs and reinstall the
1-1/4 x 12-1/2 Pin, 1-1/4 x 2-1/2 12ga Washer and
1-1/4 x 2 Roll Pin. See Figure 2-10.
2. Mount the Drawbar to the lugs on the front of the
frame, slide the 1-7/16 x 10-1/4 Pins into the frame
bushings. Place a 1-1/2 x 2-1/4 x 10ga Washer on
each end of Pin and secure with 3/8 x 2-1/4 Roll Pins.
3. Install the Turnbuckle to the Leveler with 1-1/4 x 8-1/4
Pin. Place a 1-1/4 x 1-7/8 x 14ga Washer on each end
of pin and secure with 5/16 x 2 Roll Pins.
4. Attach the Jack to the Drawbar using four 3/4-10 x
2-1/2 Bolts and Locknuts.
5. Attach the Hose Holder Bracket to the Drawbar using
3/4-10 x 7 Bolt, with flange up thread one 3/4-10
Serrated Flange Nut onto the bolt, place the Hose
Holder Bracket over the bolt and against the flange of
the installed nut. Thread the second 3/4-10 Serrated
Flange Nut with flange down tight. Nut serrations
should be against Bracket. Bracket should swivel
when installed.
6. Attach the Connector Holder using two 1/4-20 x 1
Bolts and Locknuts.
7. Hose Holder Clamp and Hose Holder Wing Nut can
be installed now or after Hydraulic Hoses are
installed. Insert 3/8-16 x 5 Bolt into Hose Holder
Bracket and secure with Hex Nut. Place Hose Holder
Clamp over the bolt and secure with Hose Holder
Wing Nut.
2-10
TABLE OF CONTENTS
F-982-0223
Advertisement
