ABB RELION 670 Series Technical Manual page 306

Section 7
Impedance protection
Name Values (Range)
TimerLinksZ4 LoopLink (tPP &
tPG)
LoopLink &
ZoneLink
no links
TimerModeZ5 Disable all
Enable Ph-G
Enable PhPh
Enable Ph-G PhPH
TimerLinksZ5 LoopLink (tPP &
tPG)
LoopLink &
ZoneLink
no links
TimerModeZRV Disable all
Enable Ph-G
Enable PhPh
Enable Ph-G PhPH
TimerLinksZRV LoopLink (tPP &
tPG)
LoopLink &
ZoneLink
no links
Table 144: ZMFPDIS (21) Non group settings (basic)
Name Values (Range)
GlobalBaseSel 1 - 12
ZDbRepInt 1 - 300
ZMax 0.0 - 5000.0
ZRepTyp Cyclic
Dead band
Int deadband
ZAngDbRepInt 1 - 300
Table 145: ZMFPDIS (21) Non group settings (advanced)
Name Values (Range)
ZZeroDb 0 - 100000
ZHiHiLim 0.0 - 5000.0
ZHiLim 0.0 - 5000.0
ZLowLim 0.0 - 5000.0
ZLowLowLim 0.0 - 5000.0
ZMin 0.000 - 5000.000
ZLimHys 0.000 - 100.000
Table continues on next page
300
Unit Step Default
- - LoopLink (tPP &
tPG)
- - Enable Ph-G
PhPH
- - LoopLink (tPP &
tPG)
- - Enable Ph-G
PhPH
- - LoopLink (tPP &
tPG)
Unit Step Default
- 1 1
Type 1 10
Ohm 0.1 1500.0
- - Cyclic
Type 1 10
Unit Step Default
m% 1 100
Ohm 0.1 1350.0
Ohm 0.1 1200.0
Ohm 0.1 300.0
Ohm 0.1 150.0
Ohm 0.001 0.005
% 0.001 5.000
1MRK 502 066-UUS B
Description
How start of trip delay timers should be
linked for zone 4
On/off setting for Ph-Ph and Ph-G trip
output, zone 5
How start of trip delay timers should be
linked for zone 5
On/off setting for Ph-Ph and Ph-G trip
outout, zone RV
How start of trip delay timers should be
linked for zone RV
Description
Selection of one of the Global Base Value
groups
Cycl: Report interval (s), Db: In % of range,
Int Db: In %s
Maximum value in ohm
Reporting type
Cycl: Report interval (s), Db: In % of range,
Int Db: In %s
Description
Zero point clamping
High High limit in ohm
High limit in ohm
Low limit in ohm
Low Low limit in ohm
Minimum value in ohm
Hysteresis value in % of range and is
common for all limits
Technical manual