ABB RELION 670 Series Technical Manual page 264

Section 7
Impedance protection
Name Values (Range)
IMinPUPP 10 - 1000
IMinPUPG 10 - 1000
IMinOpIR 5 - 1000
Table 128: ZMRPDIS (21) Non group settings (basic)
Name Values (Range)
GlobalBaseSel 1 - 12
Table 129: ZMRAPDIS (21) Group settings (basic)
Name Values (Range)
Operation Disabled
Enabled
OperationDir Non-directional
Forward
Reverse
X1PP 0.10 - 3000.00
R1PP 0.01 - 1000.00
X1PG 0.10 - 3000.00
R1PG 0.01 - 1000.00
RFPP 0.10 - 3000.00
X0PG 0.10 - 9000.00
RFPG 0.10 - 9000.00
R0PG 0.01 - 3000.00
OperationPP Disabled
Enabled
OpModetPP Disabled
Enabled
tPP 0.000 - 60.000
OperationPG Disabled
Enabled
OpModetPG Disabled
Enabled
tPG 0.000 - 60.000
IMinPUPP 10 - 1000
IMinPUPG 10 - 1000
258
Unit Step Default
%IB 1 20
%IB 1 20
%IB 1 5
Unit Step Default
- 1 1
Unit Step Default
- - Disabled
- - Forward
Ohm/p 0.01 30.00
Ohm/p 0.01 5.00
Ohm/p 0.01 30.00
Ohm/p 0.01 5.00
Ohm/l 0.01 30.00
Ohm/p 0.01 100.00
Ohm/l 0.01 100.00
Ohm/p 0.01 15.00
- - Enabled
- - Enabled
s 0.001 0.000
- - Enabled
- - Enabled
s 0.001 0.000
%IB 1 20
%IB 1 20
1MRK 502 066-UUS B
Description
Minimum operate delta current for Phase-
Phase loops
Minimum pickup phase current for Phase-
to-ground loops
Minimum operate residual current for
Phase-Ground loops
Description
Selection of one of the Global Base Value
groups
Description
Operation Disabled/Enabled
Operation mode of directionality NonDir /
Forw / Rev
Positive sequence reactance reach Ph-Ph
Positive seq. resistance for characteristic
angle, Ph-Ph
Positive sequence reactance reach Ph-G
Positive seq. resistance for characteristic
angle, Ph-G
Fault resistance reach in ohm/loop, Ph-Ph
Zero sequence reactance reach, Ph-G
Fault resistance reach in ohm/loop, Ph-G
Zero seq. resistance for zone
characteristic angle, Ph-G
Operation mode Disable/Enable of Phase-
Phase loops
Operation mode Disable/Enable of Zone
timer, Ph-Ph
Time delay of trip, Ph-Ph
Operation mode Disable/Enable of Phase-
Ground loops
Operation mode Disable/ Enable of Zone
timer, Ph-G
Time delay of trip, Ph-G
Minimum operate delta current for Phase-
Phase loops
Minimum pickup phase current for Phase-
to-ground loops
Technical manual
PID-3648-SETTINGS v5