Figure 41: Connecting The Ac Power Cord Retainer Clip To An Ac Power Supply In An Ex4200 Switch; Figure 42: Connecting An Ac Power Cord To An Ac Power Supply In An Ex4200 Switch - Juniper EX4200-24T Hardware Manual

Related
Documentation
Copyright © 2017, Juniper Networks, Inc.
If the AC power source outlet has a power switch, set it to the ON (|) position.
8.
Verify that the AC OK LED on the power supply is lit and is on steadily.
9.
NOTE: When you connect power to the switch, the Alarm (ALM) LED lights
red. This behavior is normal. Plugging an active Ethernet cable into the
management (MGMT) port on the switch completes the network link and
turns off the ALM LED. (See
Out-of-Band Management" on page
Connecting the switch to a dedicated management console instead of a
network does not affect the ALM LED. The LED remains red until the switch
is connected to a network.
Figure 41: Connecting the AC Power Cord Retainer Clip to an AC Power
Supply in an EX4200 Switch
Figure 42: Connecting an AC Power Cord to an AC Power Supply in an
EX4200 Switch
Connecting and Configuring an EX Series Switch (CLI Procedure) on page 165
Connecting and Configuring an EX Series Switch (J-Web Procedure) on page 168
Connecting DC Power to an EX4200 Switch on page 152
Power Supply in EX4200 Switches on page 33
AC Power Supply LEDs in EX4200 Switches on page 37
Chapter 13: Connecting the Switch to Power
"Connecting a Device to a Network for
157.)
151