Connecting Dc Power To An Ex3200 Switch; Figure 35: Connecting The Ac Power Cord Retainer Clip To An Ac Power Supply In An Ex3200 Switch; Figure 36: Connecting An Ac Power Cord To An Ac Power Supply In An Ex3200 Switch - Juniper EX3200 Hardware Manual

Related
Documentation

Connecting DC Power to an EX3200 Switch

Copyright © 2017, Juniper Networks, Inc.
If the AC power source outlet has a power switch, set it to the ON (|) position.
8.
Verify that the AC OK LED on the power supply is lit and is on steadily.
9.
NOTE: When you connect power to the switch, the Alarm (ALM) LED lights
red. This behavior is normal. Plugging an active Ethernet cable into the
management (MGMT) port on the switch completes the network link and
turns off the ALM LED. (See
Out-of-Band Management" on page
Connecting the switch to a dedicated management console instead of a
network does not affect the ALM LED. The LED remains red until the switch
is connected to a network.
Figure 35: Connecting the AC Power Cord Retainer Clip to an AC Power
Supply in an EX3200 Switch
Figure 36: Connecting an AC Power Cord to an AC Power Supply in an
EX3200 Switch
Connecting and Configuring an EX Series Switch (CLI Procedure) on page 145
Connecting and Configuring an EX Series Switch (J-Web Procedure) on page 148
Connecting DC Power to an EX3200 Switch on page 131
Power Supply in EX3200 Switches on page 29
AC Power Supply LEDs in EX3200 Switches on page 32
The power supply in an EX3200 switch is a field-replaceable unit (FRU).
Chapter 12: Connecting the Switch to Power
"Connecting a Device to a Network for
137.)
131