Important Functions For The Project Handling During Commissioning - Siemens SIMOTION D4 5-2 Series Commissioning And Hardware Installation Manual

Commissioning (software)
6.1 Overview of commissioning
6.1.3

Important functions for the project handling during commissioning

The following functions are very important for the project handling and commissioning:
Table 6- 2
Symbol
Note
Tips for going ONLINE:
In online operation, SCOUT attempts to conduct online operation with all hardware
components contained in the project. This means that the time needed for going online
increases.
We recommend that you make settings for SCOUT so that online operation is made only
with those components currently needed. The setting can be found at "Target system >
Select target devices..." in the menu. The selection and deselection of the devices in the
online state can be made via the "Connect target device" context menu on the device.
This procedure is also advantageous when the configuration of the drive unit is completed.
Without going completely offline, the connection can be simply deselected via the context
menu on the drive unit.
158
Buttons for operator control
Function Effect
Save project Select Save project and compile changes to save the entire project
and compile and compile the project data (e.g. programs) in an executable
changes code. Only the changes are compiled. Unchanged code is
retained.
Connect to The online connection is established to the selected target devices.
selected target Under "Target system" > "Select target devices", you can set which
devices target devices are to go online.
Download Downloading programs to the SIMOTION device and performing
project to target configuration for the SINAMICS Integrated and any connected
system CX32-2 modules.
Download CPU / The configuration is only loaded to the device selected in the
drive unit to project tree (which means that the function needs to be performed
target device separately for each D4x5-2/CX32-2 and each SINAMICS
Integrated).
Load CPU / The unit's configuration is only loaded to the PG selected in the
drive unit to PG project tree (which means that the function needs to be performed
separately for each D4x5-2/CX32-2 and each SINAMICS
Integrated).
Copy RAM to Copying from RAM to ROM is only performed for the device
ROM selected in the project tree (which means that the function needs to
be performed separately for each D4x5-2/CX32-2 and each
SINAMICS Integrated).
Commissioning and Hardware Installation Manual, 02/2012
SIMOTION D4x5-2