Siemens SIMOTION D4 5-2 Series Commissioning And Hardware Installation Manual page 210

Commissioning (software)
6.5 Additional information on configuring the SINAMICS Integrated
If you change the settings for the SINAMICS Integrated, you must also change the settings
on the CX32-2 modules accordingly. This is easily done by using the Align button to transfer
the settings for all the CX32-2 modules.
Figure 6-33 HW Config - settings
The times are modified by changing the value in the "Factor" field.
Additional references
Further information is available in the following references:
●
●
210
SINAMICS S120
Function Manual
SIMOTION SCOUT Basic Functions
Function Manual
Commissioning and Hardware Installation Manual, 02/2012
SIMOTION D4x5-2