Siemens SIMOTION D4 5-2 Series Commissioning And Hardware Installation Manual page 156

Commissioning (software)
6.1 Overview of commissioning
Adaptation
In addition to the symbolic assignment, the automatic adaptation facilitates the configuration
of SINAMICS S110/S120 data as of SIMOTION V4.2. During power-up of the SIMOTION
devices, reference variables as well as drive and encoder data of the SINAMICS S110/S120
are automatically taken over for the configuration data of the SIMOTION technology objects
"TO axis" and "TO externalEncoder". This data no longer has to be entered in SIMOTION.
For additional information, see the following sources:
●
●
Requirement
The symbolic assignment is supported by the TO axis, TO externalEncoder and the
TO outputCam, TO camTrack and TO measuringInput. The onboard I/Os of a SIMOTION D,
of a SINAMICS S110/S120 control unit as well as from a TB30 and selected terminal
modules can be interconnected symbolically.
Table 6- 1
Module
SIMOTION D410-2
SIMOTION D410
SIMOTION D4x5-2
SIMOTION D4x5
Controller extension
•
•
SINAMICS S110 CU305
SINAMICS S120
•
•
•
•
See also
Only the drive configuration by means of symbolic assignment is described in this
documentation.
On the Internet, you can find documentation of older SIMOTION versions at:
(http://support.automation.siemens.com/WW/view/en/40211807)
For further information on the configuration of the TO axis and TO externalEncoder, refer to
the
156
SIMOTION SCOUT Basic Functions
TO Axis Electric/Hydraulic, External Encoder
Control units that support a symbolic assignment
CX32-2
CX32
CU310-2
CU310
CU320-2
CU320
TO Axis Electric/Hydraulic, External Encoder
Function Manual
Function Manual
Supports symbolic assignment
As of SIMOTION V4.3
As of SIMOTION V4.2
As of SIMOTION V4.2
As of SIMOTION V4.2
As of SIMOTION V4.2
As of SINAMICS V4.3
As of SINAMICS V4.4
•
As of SINAMICS V2.6.2
•
As of SINAMICS V4.3
•
As of SINAMICS V2.6.2
•
Function Manual.
Commissioning and Hardware Installation Manual, 02/2012
SIMOTION D4x5-2