Properties Of Profinet; Configuration Tasks - Siemens SIMOTION D4 5-2 Series Commissioning And Hardware Installation Manual

5.6.3

Properties of PROFINET

Properties
The onboard PROFINET IO interface supports the parallel operation of:
● IRT - isochronous real-time Ethernet
● RT - real-time Ethernet
● TCP/IP, UDP, HTTP, ... standard Ethernet services
Note
For mixed operation of IRT and RT, make sure that the IRT-compatible devices form what is
referred to as an IRT domain; i.e. there must not be any non-IRT devices on the data
transmission link between the IRT devices.
Additional references
You will find an overview of the specific properties of PROFINET IO on SIMOTION D in the
SIMOTION Communication
5.6.4

Configuration tasks

Configuration of PROFINET involves the following steps:
1. Insert the SIMOTION D4x5-2.
2. Configure the onboard PROFINET IO interface in HW Config.
3. Create a topology: Here, you specify how the individual ports of the PROFINET IO
4. Configure the sync domain: Here, you specify which PROFINET nodes are sync masters
5. Specify the send clock: Describes the time during which a PROFINET IO device
6. Configure the direct data exchange: The direct data exchange specifies which address
Additional references
You will find a detailed description of each configuration step in Section "Configuring
PROFINET IO with SIMOTION" of the
SIMOTION D4x5-2
Commissioning and Hardware Installation Manual, 02/2012
– Operation of IRT I/O (e.g. ET 200S)
– Operation of a SINAMICS S120 as IRT device
– Operation of RT I/O (e.g. ET 200S, ET 200pro, etc.)
– Operation of a SINAMICS S120 as an RT device
devices are interconnected.
(clock generators) and sync slaves.
exchanges user data with the PROFINET IO controller.
areas are to be used for sending and receiving respectively.
System Manual.
SIMOTION Communication
Parameter assignment / addressing
5.6 Configuring PROFINET IO
System Manual.
151